Control Freak - 2 sets of data from one slider (1 inverted) using software to program?

chrisr

Senior Member
Hello to any Kenton Control Freak Gurus...

I'm reconfiguring my Freak and would like to send CC89 (0-127) and simultaneously CC90 (inverted 127-0) from the same fader. I'm certain it's possible, but it's my first time trying to assign multiple commands to one controller.

I'm reading the "Invert Data" example from the manual, but it's written as if entering the info from the CF front panel. I'm finding it hard to translate that example into a command chain in the CF software - could anyone help with a screenshot of how that command chain might look in the software? - or any other tips / pointers about layering commands in the software prior to midi send to the unit.

many thanks in advance!

best,
Chris
 
OP
chrisr

chrisr

Senior Member
Now sorted - I just stopped being lazy and did it on the hardware, then imported that back into the software to examine. All good now.